bone swiss bearings
BONES BEARINGS
Bones Swiss Skateboard Bearings have the best reputation in the skateboard industry, and have had this honor for the past 28 years because of their performance and quality. Everyone who rides Swiss knows how fast they are, and most also comment on how long they last, typically several times as long as low cost bearings. Skaters who use Bones Swiss do so because they want the very best equipment they can get and they know the difference between ordinary and exceptional. Our team is a who’s who of top skaters and we are proud to be associated with each one of them.
Your new Bones Bearings are the most accurately manufactured part of you skateboard, with clearances and tolerances considerably smaller than 1/1000th of an inch. That means that a single hair is thicker than the clearance between the balls and the races inside the bearing, and a hair will clog it up and slow you down. Because you skateboard outside through dust, sand, water, mud, etc; your bearings will eventually get dirty and/or wet. When they are dirty, you will notice they don’t spin freely when you flick the wheel and you may also notice they are getting noisy. At this point you have two options: clean your bearings or replace them.
WARNING! Don’t continue to use bearings that don’t spin freely on your skateboard. If you continue to ride very dirty or un-lubricated bearings, you run the risk of permanently damaging them and/or yourself. Dirt in your bearings will cause pitting of your balls and races, increase friction, cause extra heat, and can eventually cause the bearing to “freeze up” or stop rolling. If this happens to your bearings, the skateboard will stop abruptly, causing you to fall and be injured. So keep them clean, dry and lubricated with Speed Cream.